English to Slovenian Tech/Engineering Other

Control of the bottom sensor. The test simulates water resistance with very low conductivity.
- Place the resistance box 14 kΩ over the sensors in the bottom of the tub.
- The plug on the box shall be placed in the middle (and straight up).
- Ensure that diode 2 on the Water Level of the PCB flashes.
- Mark in the test sheet.
Control of fill stop. Connect the plug on the resistance box to the side where the level sensor is situated.
- Place the plug of the resistance box on the level sensor holding only the isolated part of the wire.
- Ensure that diode 2 and 3 on the Water Level of the PCB flashes.
- Mark in the test sheet.
- Remove the resistance box.